Eminent EM6556 Specifications download pdf (Page 5)

5 | ENGLISH

6. Connect the switching wire of the lamp with the LS input of the mini switch. Often

this wire has a black color.

7. Connect the 230v live wire of the mains with the L input of the mini switch. Often

this wire has a brown color.

8. Make sure all wires are fully inserted into the mini switch.

9. Turn on the main switch to enable the mains again.

10. Test whether the device works by pressing the button on the switch. (be careful

and avoid touching the wires). The LED on the switch will be lit. The connected

device will also be turned on.

11. Do not close the junction box yet.

3.2 Assigning the mini switch to the e-Domotica e-Centre

There are two situations possible when assigning the switch to the Eminent e-Centre.

1. You assign the switch to the e-Domotica e-Centre during the installation process

of the e-Centre itself. The installation wizard of the e-Centre will move along

several steps during the installation process of the e-Centre itself, meaning you

can add all your e-Domotica devices through the e-Centre’s own website

“http://ecentre”. For this installation you have to follow the steps shown on

screen.

2. You can add your switch to the already installed e-Centre. This is described in

the next chapter.

Note that you might need to enable the checkbox ‘Normal/High Power’ just below the

‘Include’ button on the ‘e-Domotica Products’ page of your e-Centre. This option is

available to be able to include devices on a greater range. For example, your e-Centre

is located in the living room and the EM6556 is located in the attic of your house.

3.3 Adding the switch to the already installed e-Domotica

e-Centre

1. Make sure your computer is completely started.

2. Open your computer’s web browser.

3. Fill in “http://ecentre” in the address bar of your web browser and press the

‘Enter’ key on your keyboard.

4. The webpage of the e-Centre will be shown. If the Wizard is started, click ‘Exit

Wizard’ to go to the ‘e-Domotica Products’ page.

5. Click the ‘Include’ button. The e-Centre will start to search for new e-Domotica

devices.

6. Press the button on your new switch three times.

7. A message will appear: ‘Product found’.

If the device is not found, press the ‘Exclude’ button in the e-Centre’s webpage and

then click the button on your switch. After this procedure you can add the new device

correctly.

1 2 3 4 5 6 7 8 9

No comments

Eminent EM6556 Specifications Page 5