Eminent EM6561 Installation Guide download pdf (Page 25)

25 | ENGLISH

Image 19 – Step 7 – Setup e-Domotica IP Cameras

The e-Centre can find the camera if the camera is connected (wired or wirelessly) to

the same network were the e-Centre is connected to. At the top of the page you see a

list ‘Configured Cameras’, this will be the list of connected cameras. At the bottom of

the page you will see ‘Detected Cameras in your network’.

Note! The e-Domotica IP Cameras need to be connected to your home network

(LAN/WLAN) and do not make use of Z-wave. Make sure that each camera has been

properly installed using the instructions of the manual of the camera. If you want to

use the IP camera wirelessly, make sure it is connected to your wireless network

before you add the camera to the e-Centre using this chapter.

1. Click on the disk button to add this camera to your e-Centre. You will see the

following page.

Image 20 – Add an e-Domotica IP Camera to your e-Centre

2. The IP Address, MAC Address and Camera type are already entered.

1 2 ... 20 21 22 23 24 25 26 27 28 29 30 ... 46 47

No comments

Eminent EM6561 Installation Guide Page 25